For prototype pcb assembly, what are the requirements for PCBA splitting?

Since some prototype pcb assembly boards are relatively small in size, they are often made into panel. After the prototype pcb assemblyprocessingis completed, the prototype pcb assemblypanelsneed to be separated.The separation method is mainly divided into manual and machine splitting. During the splittingprocess, some precautions should be taken to prevent damage to the intact PCBA board.

First, the requirements of manual splitting

1. When splitting the edge of the board, you must hold the lower edge of the PCBApanel with twohands, and go to the place below 20mm from the V-cut to avoid bending deformation, PCBA electrical circuit and parts, and damage of the tin track.

Second, the requirements of the machine splitting

1. Stable support points

Without support, the resulting stress can damage the substrate and solder joints. Distorting the board, or producing assembly stress during the splitting, can result in hidden or significant defects.

2.Wearingprotective tools

Before proceeding, be sure to prepare for protection. You need to install high-frequency eye protectiondeviceto protect the safety of the operator. It is best to weara pair of glassto protect your eyes.

3. Always wipe the machine shaft and tool with alcohol to remove the PCB dust generated during thepanel splittingprocess and maintain the normal operation of the prototype pcb assemblymachine.

4. After operatinga certain number of times, it is necessary to smooth the sliding rods and bearings of the splitterand check whether the screws are loose or not.

5. In the operation process of machine , the work benchshould be kept clean. It is best not to place other things to avoid damage to the tool and damage to the goods. Although there are electric eyes for maintenance, it is necessary to pay attention to the safe interval between the finger and the tool during the application process.

In general, when the PCBA is splitting, the machine prototype pcb assembly board is more efficient and the damage rate is lower than the manual splitting. However, when performing machine splitting, it is necessary to strictly follow the process to reduce human error.